Bead Nabber Banner
 
Participate
eCards
Chat Room
VFB Wear
Forums
Recipes
Add Recipe
Auctions
E-Mail List
Add-A-Fly
Membership
Guestbook
Search
VFB Scrapbook
A collection of photographs and stories submitted by our loyal viewers to share with our friends. If you have any interesting pics that you'd like others to see online be sure to contact us.
VFB Forums
Take a look at our recently added NEW Bulletin Board! A great place to announce your swaps, ask fly tying questions, post your trip reports or share a favorite pattern. Just CLICK HERE to enter now.
Swaps
The heart and soul of the Virtual Flybox are the fly swap pages. You will discover hundreds of patterns from all around the world with full color photos and tying instructions.
VFB Auctions
One central forum for all goods related to fly fishing and tying. This is the place to sell your extra goodies or find that special bargain. For a limited time no listing fees or commissions will be charged...Sign up now!
VFB Statistics
1177 Patterns   25 Articles
453 Tyers   36 Swaps
11 eCards   152 Recipes
Site Credits


Check out the Top 50 Fly Fishing sites!
 
Send as VFB eCard
Female Trico
Tied by Michael Nych
  • Thorax: Black beaver dubbing (fine)
  • Wing: Light Dun CDC feather
  • Hook: size 22 - 28 Tiemco TMC 100, 101, or equiv
  • Thread: White 8/0
  • Tail: White or Light Dun microfibetts
  • Tying Instructions
    • Start thread behind eye and wind back to just above the point.


    • Tie in three microfibetts about 3-4 shank lenghts and wind down to the bend (tails should point down slightly. Make 1 wrap UNDER the tails to pull them up and splay them. Wrap over butt ends to point of thread tie in and clip butt ends.


    • Prepare 1 CDC feather as follows.
      - Holding feather by the tip, stroke barbules down towards butt.
      - Clip stem, removing the short barbules.


    • Gather the ends of the feather by pulling it between your thumb and index finger and bind down on top of hook with (tips facing the bend and butt over the eye) with 2 light turns. These wraps are over the part of the feather that still has the stem.


    • Turn feather perpendicular to shank and figure eight lightly.


    • SLOWLY pull feather till you have set the far side wing approx. 1 1/2 shank length. You will feel the butt pull free of the wraps. Bind donw with another figure eight but tighter this time.


    • Dub a VERY SMALL amount of black beaver dubbing (guard hares removed) and pack it down tight on the thread. Figure eight around the wings to form the thorax.


    • Finish fly by making 1 half hitch and a 3-4 turn whip finish.


    • Trim far wing to 1 shank length. Do the same for the near wing (it should not have any stem in it when trimmed).


    • Trim the tails to 2 to 2 1/2 shank lengths.
    Fishing Tips
    I fish this fly on "longish" leaders (12+ feet). It sometimes helps to apply a very small amount of indicator putty to the leader about 12-18 inches from the fly if there are alot of naturals in the water or if your vision isn't the greatest, like mine ;^). Set the hook to any rise within that radius of the indicator.
    Michael Nych
    Exton, PA United States

    Send Email
    << Back Next >>

    ZDO Banner Line's End Inc Banner
    As Seen In Fly Tyer Order Today And $ave
     
     
    The Virtual Flybox is made available through Membership support.
    Copyright © 1997-2006 All Rights Reserved.